Remington AS5901 Manual page 4

ENGLISH
• During use, always ensure the inlet and outlet grilles are not blocked in any way as this
will cause the unit to automatically stop. If this should occur, switch off and allow the
unit to cool.
• Keep the power plug and cord away from heated surfaces.
• Do not leave the appliance unattended while plugged in.
• Do not place the appliance on any soft furnishings.
• Do not use attachments other than those we supply.
• Do not set the appliance down while still on.
• Do not twist or kink the cable, or wrap it round the appliance.
• Do not use the appliance if it is damaged or malfunctions.
• Check the cord regularly for any sign damage.
• This appliance is not intended for commercial or salon use.
PARTS
1. 1000W power handle
2. 50mm round mixed bristle brush
3. 30mm round mixed bristle curling brush
4. Attachment lock/release button
INSTRUCTIONS FOR USE
Prepare the hair for styling
• Wash and condition the hair as normal.
• Squeeze out excess moisture with a towel and comb through.
• For best results, dry your hair as normal until it is about 70-80% dry.
• Divide the hair into sections, style the lower layers first.
To fit attachments
• Fit the brush head before you turn on the appliance.
• Fit the brush as shown in figure A aligning the symbols as shown.
• To remove, press the attachment lock/release button and pull the attachment off the
power handle. Take care when you do this as attachments will be hot after use.
Speed and temperature settings
1. Plug your styler in to the mains power supply.
2. To turn your air styler on, slide the speed/heat selector switch to the F (low) or E (high)
position.
3. Your air styler has two temperature settings:
• High (E): Thick and difficult to style hair
• Low (F): Thin/fine, damaged or bleached hair
4. Use the heat selector switch to select the appropriate temperature for your hair type.
4
5. Inlet grille
Controls:
F , E Speed/heat selector switch
f Cool shot