Table of Contents
Advertisement
www.ti.com
9.5 Sensor Controller
The Sensor Controller contains circuitry that can be selectively enabled in both Standby and Active power
modes. The peripherals in this domain can be controlled by the Sensor Controller Engine, which is a proprietary
power-optimized CPU. This CPU can read and monitor sensors or perform other tasks autonomously; thereby
significantly reducing power consumption and offloading the system CPU.
The Sensor Controller Engine is user programmable with a simple programming language that has syntax
similar to C. This programmability allows for sensor polling and other tasks to be specified as sequential
algorithms rather than static configuration of complex peripheral modules, timers, DMA, register programmable
state machines, or event routing.
The main advantages are:
•
Flexibility - data can be read and processed in unlimited manners while still
•
2 MHz low-power mode enables lowest possible handling of digital sensors
•
Dynamic reuse of hardware resources
•
40-bit accumulator supporting multiplication, addition and shift
•
Observability and debugging options
Sensor Controller Studio
C driver source code, which the System CPU application uses to control and exchange data with the Sensor
Controller. Typical use cases may be (but are not limited to) the following:
•
Read analog sensors using integrated ADC or comparators
•
Interface digital sensors using GPIOs, SPI, UART, or I
•
Capacitive sensing
•
Waveform generation
•
Very low-power pulse counting (flow metering)
•
Key scan
The peripherals in the Sensor Controller include the following:
•
The low-power clocked comparator can be used to wake the system CPU from any state in which the
comparator is active. A configurable internal reference DAC can be used in conjunction with the comparator.
The output of the comparator can also be used to trigger an interrupt or the ADC.
•
Capacitive sensing functionality is implemented through the use of a constant current source, a time-to-digital
converter, and a comparator. The continuous time comparator in this block can also be used as a higher-
accuracy alternative to the low-power clocked comparator. The Sensor Controller takes care of baseline
tracking, hysteresis, filtering, and other related functions when these modules are used for capacitive
sensing.
•
The ADC is a 12-bit, 200-ksamples/s ADC with eight inputs and a built-in voltage reference. The ADC can be
triggered by many different sources including timers, I/O pins, software, and comparators.
•
The analog modules can connect to up to eight different GPIOs
•
Dedicated SPI controller with up to 6 MHz clock speed
The peripherals in the Sensor Controller can also be controlled from the main application processor.
Copyright © 2022 Texas Instruments Incorporated
is used to write, test, and debug code for the Sensor Controller. The tool produces
Product Folder Links:
SWRS263A – FEBRUARY 2021 – REVISED JUNE 2022
ensuring ultra-low power
2
2
C (UART and I
C are bit-banged)
CC2652PSIP
CC2652PSIP
Submit Document Feedback
41
Advertisement
Table of Contents
