Table of Contents
Advertisement
when the phone experiences a dropped call or failed call, or
the phone enters or leaves a service area.
.
Connect Tone
: You can set the phone to sound when your call
is connected to system.
.
Signal Fade Tone
: You can set the phone to sound when your
call is disconnected.
To turn each alert on or off:
1.
From Standby mode, press <Menu> for the Main menu.
2.
Select
8:Setup
.
3.
Select
2:Sounds
.
4.
Select
3:Alerts
.
5.
Scroll to the alert type you want to set:
Connect
or
Disconnect
6.
Select
On
or
Off
, and press <OK>.
Setting Roam Ringer
You can set the phone to use a distinctive ring for incoming
roaming calls.
1.
From Standby mode, press <Menu> for the Main menu.
2.
Select
8:Setup
.
3.
Select
2:Sounds
.
4.
Select
2:Ringer Type
.
5.
Select 4
:Roam Ringer
6.
Select
Normal
to use a normal ringer or
distinctive ringer.
7.
Press <OK> to save the selection.
Adjusting Key Beep
The keys on your phone beep when they are pressed. You can
adjust the volume of the beeps or turn them off when you do not
want the keys to beep at all.
1.
From Standby mode, press <Menu> for the Main menu.
2.
Select
8:Setup
.
3.
Select
2:Sounds
.
4.
Select
4:Key Tones
.
5.
Select
2:Key Beep
.
6.
Scroll to the desired key volume and press <OK> to select.
Setting Tone Length
The tone length setting enables you to select Normal or Long
DTMF (Dual-tone multi-frequency) tones. When you use a
teleservice, such as your bank account, and press the keys to
enter numbers into the teleservice, you are sending DTMF tones.
The system used by the bank or other service determines if you
need short or long DTMF tones. If the service is digital which
most are these days, normal DTMF will almost always work.
However, some new systems and almost older systems require
long DTMF tones.
To set the tone length:
1.
From Standby mode, press <Menu> for the Main menu.
2.
Select
8:Setup
.
3.
Select
2:Sounds
.
4.
Select
5:Tone Length
Minute Beep
.
.
Distinctive
.
,
Service
,
to use a
Hide quick links:
Advertisement
Table of Contents
