Advertisement
Quick Links
Sharp SmartPunch
Contents
1.
2.
Configurations
3.
4.
5.
6.
7.
8.
ACCO Brands, Inc.
Four Corporate Drive
Lake Zurich, IL 60047
www.acco.com
Installation Manual
Sharp SmartPunch Plus Installation Manual
Plus
™
Page
2
2
2
3
4
5
9
10
Part No.
7724542
Rev No.
C1
Issue Date:
June, 2021
1
Advertisement
Summary of Contents for GBC SmartPunch Plus
-
Page 1: Table Of Contents
Configurations Sheet guides installation Docking Bracket Installation Cable connections Leveling & Height Adjustment Final Steps Part No. 7724542 Rev No. ACCO Brands, Inc. Issue Date: June, 2021 Four Corporate Drive Lake Zurich, IL 60047 www.acco.com Sharp SmartPunch Plus Installation Manual... -
Page 2: Recommendations And Pre-Requisites
1. Recommendations and Pre-requisites You will need the installation kit provided with the SmartPunch Plus unit, which can be found in the main carton. 2. Unpacking Inspect the outside of the package for shipping damage. If there is evidence of shipping damage, contact the shipping carrier immediately. - Page 3 Exit Upper Guide Exit Lower Guide (Angled type) Communication Cable Assembly Left Docking Bracket Right Docking Bracket Power Cord 115V: US 230V: UK, Swiss, and EU M4-8mm long Round Tipped Screw Installation Manual User Manual Sharp SmartPunch Plus Installation Manual...
-
Page 4: Sheet Guides Installation
Install the entrance guide provided in the Installation kit with the supplied M4-8mm long round tipped screws (2 Nos.). When Installing the SmartPunch Plus downstream from the MX-CF11（Inserter Unit), the following procedures are needed before installing the entrance side guides. - Page 5 4.2 Exit side guides Install the Angled Exit guide with the supplied M4-8mm long round tipped screws (2 places) Attach exit upper guide with the supplied M4-8mm long round tipped screws Sharp SmartPunch Plus Installation Manual...
-
Page 6: Docking Bracket Installation
Install the bracket marked “L” on the left side facing you. Both brackets should be oriented with the arrow facing up. When installing the SmartPunch Plus downstream from the MX-RB18（Curl Correction Unit） When Install the SmartPunch Plus downstream to MX-CF11（Inserter Unit）... -
Page 7: Cable Connections
Remove the finisher rear maintenance cover and plug the 7 pin communication cable to CN145 on the finisher control board. The communication cable is provided in the Installation kit of SmartPunch Plus. Attach the bracket tied to the communication cable with the supplied M4-8mm long round tipped screws (2 places). Sharp SmartPunch Plus Installation Manual... -
Page 8: Leveling & Height Adjustment
Plug the free end of the communication cable to the communication port of the SmartPunch Plus in the rear side of the machine. c) Replace the finisher rear maintenance cover. Ensure that the communication cables are not pinched anywhere. -
Page 9: Final Steps
Confirm that the printer and finisher have the latest firmware installed. Firmware is available for download 8.2 Enabling the Punch Icon The power switch for the SmartPunch Plus can be found on the front frame on the lower right position (shown below). Turn the SmartPunch Plus on before the main unit. - Page 10 Run each die set to punch 100 sheets or until there is no oil residue around the holes. 8.4 User manual Print a copy of SmartPunch Plus User manual from the supplied CD and leave it at the install location Sharp SmartPunch Plus Installation Manual...