Using Your Remote Control - RocketFish RF-RBREC User Manual

On the non-hub source unit to be added to the network, press and hold
2
the power button for more than three seconds. The power indicator
begins to blink blue.
The units will automatically discover each other, link, and autoconfigure.
The indicators of the hub and the new source device change to solid
green and blue respectively.
Tuning in to a station
Active station capacity is limited to five stereo stations of CD quality
audio. If the same streams are configured as HD, there is less capacity
available because HD channels carry more data.
The following configurations are possible:
• 5 x stereo (CD) stations
• 1 x stereo (HD) station + 3 x stereo (CD) stations
• 2 x stereo (HD) stations + 2 x stereo (CD) stations
• 3 x stereo (HD) stations
Each receiver has a station select command activated by pressing the
SOURCE button. The command, called "Next source, " advances
sequentially through each active station, indexing one active station
each time it is pressed.

Using your remote control

• To avoid possible failure, read the following instructions and handle the
remote control properly.
• Do not drop or jar the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of
excessive heat.
Caution: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type of battery.
Note: Remove the battery from the remote control when it is not to be used for a long
period. Otherwise it might be damaged due to battery leakage.
26