Viessmann VITODENS 200-W B2HE 85 Operating Instructions Manual page 30

Additional Adjustments
Switching Internet Access On or Off
Establishing a WiFi connection
Note: Prerequisite: WiFi is switched on.
Tap the following buttons:
1.
2. "Settings"
3. "Internet"
4. "Network selection"
Available WiFi networks are displayed.
Note: If a connection as already exists, "Connected"
is shown next to the relevant network.
If you want to use an invisible WiFi network:
Tap and enter the name of the WiFi network
(SSID) and the password.
5. Select WiFi.
Note: Use to refresh the list of available WiFi
networks.
6. to confirm
7. If your selected WiFi is not protected
to acknowledge the connection message
or
If your selected WiFi is protected
Enter the password (maximum 40 characters).
to confirm your password
8. to confirm the prompt about internet use
The default display shows
Note: If the connection was not established, an
error message is shown.
An internet connection only exists if the
selected
WiFi is connected to the internet.
Check your WiFi settings if necessary.
30
(continued)
:
:
.
Static IP address
Prerequisite: Your WiFi is configured so that the subscriber
addresses in the network (IP addresses) are not automatically
assigned.
Tap the following buttons:
1.
2. "Settings"
3. "Internet"
4. "Network selection"
5. Available WiFi networks are displayed.
Note: Tap to refresh the list of available WiFi
networks.
6. Select the network.
7.
8. "STATIC" for static IP address
9. to confirm
10. Enter network data:
IP address
Subnet mask
Standard gateway
Primary DNS server
Secondary DNS server
11. to confirm
Note: An internet connection only exists if the selected
WiFi is connected to the internet. Check your WiFi
settings if necessary.
Vitodens 200-W B2HE Operating