ENGLISH Before using this device, be sure to read this manual thoroughly for safe use of it� After that, keep this manual in a safe place and read it whenever necessary� Safety Precautions === Be sure to observe the following precautions === In order to use this device properly, the contents to be observed are explained, classified as follows�...
Page 4
Warnings Never disassemble or modify the device Do not operate with wet hands� <<A short circuit or an electric shock may occur�>> Cautions Avoid water, moisture, dust and high temperature • Do not store or use the device in places such as a bath or outdoors where water splashes�...
You can charge the wireless units by using a micro USB Type-B Y-cable (included) with your own USB power adapter� NOTE: While charging, the LED lights red and WS1 doesn’t work as a wireless system� When it’s fully charged, the LED turns off�...
Page 7
After 2 seconds, they will be paired automatically and both of the LEDs lights green� The WS1 will choose the best wireless channel automatically in 2�4 GHz frequency band� If the receiver can’t detect a signal coming from the transmitter, the receiver’s LED will blink red�...
Page 8
The WS1 has a cable tone filter function which simulates a 3 m (10 ft�) high grade guitar cable connecting to a passive guitar� By clicking the power button , the cable tone filter is engaged and LED lights orange�...
Page 9
• ID matching The WS1 transmitter and receiver have already assigned unique matched ID at the factory� If you want an another WS1 transmitter or receiver to get paired, follow the following steps to reset ID matching� (1) Turn off all the WS1 transmitter and receiver around you�...
Specifications Operating Frequency 2�4GHz Audio Quality 24-bit/44�1kHz Signal Transmission Latency < 5ms Line-of-signt Range Up to 30m / 100ft Frequesncy Response 20Hz - 20kHz THD + Noise < 0�05% @ 1kHz, -10dBFS Battery Built-in Li-ion rechargeable battery Battery Capacity 3�7V/500mAh Battery Life (Continuous Use) 4 hours (max�...
Page 11
This device complies with part 15 of the FCC Rules� Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation� NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules�...
Page 12
Simplified EU Declaration of Conformity Hereby, Hoshino Gakki Co�, Ltd� declares that the radio equipment type WS1 is in compliance with Directive 2014/53/EU� The full text of EU declaration of conformity is available at the following internet address: http://www.hoshinogakki.co.jp/pdf/ibanez/declaration/en/WS1.pdf...