Advertisement
Quick Links
Advertisement
Summary of Contents for Kyocera LDM-410
- Page 1 LDM-410 69800933-00 STD 10-21...
-
Page 2: Safety Instructions
THANK YOU FOR BUYING OUR PRODUCT. To ensure your safety and satisfaction, carefully read through this OWNER’S MANUAL before using the product. CAUTION! Read, understand and follow all Safety Rules and Op- erating Instructions in this Manual before using this product. SAFETY INSTRUCTIONS WARNING: BE SURE to read and understand all instructions in this manual before using this product. - Page 3 Do not use on surfaces such as sheet steel that have shiny, reflective surfaces. • The reflective surface could reflect the beam back at the operator. Always turn the laser tool off when not in use. Leaving the tool on increases •...
- Page 4 ...
-
Page 5: Specifications
DESCRIPTION 1. Display 2. Measuring button 3. On/Off button 4. Mode switch button 5. Reference mark for wheel measurement 6. Receiver lens 7. Laser output part 8. USB port (Micro B) 9. Wheel SPECIFICATIONS Measurement range 0.2 - 40m *1 Measurement accuracy ±3mm *2 Minimum measurement unit... - Page 6 DISPLAY 1. Measurement reference (Front/Rear) 2. Laser indicator 3. Battery level 4. Previously measured value 5. Current measured value 6. Measuring unit CHARGING This product has a built-in lithium battery. Please use the original USB cable while charging. Laser distance meter may heat up a little when charging, it's normal, has no effect on the device performance and service life.
-
Page 7: Operation
OPERATION 1. Single Measurement The device will enter single measurement when it is powered ON, press measuring button after aiming at target to get result at bottom of the screen. 2. Continuous Measurement Long press measuring button to activate continuous measurement, aiming at the target and press measuring button to stop, the current data will be displayed accordingly. - Page 8 End point Start point Wheel Reference mark USING TRIPOD Use the adapter included as a standard accessory when mounting the device on a commercially available tripod. Attaching the adapter Peel off the paper on the double sided tape and paste the adapter at the center of the device.
- Page 9 ERROR CODE-REASON AND SOLUTION All information will be showed as code or “Error’, the following are all codes and corresponding solutions. Code Cause Corrective measure Calculation error Switch on/off the device several times and measure again. Battery low Charge the device Received signal is too Improve the reflective surface.
- Page 10 - NOTE - ...
- Page 11 - NOTE - ...