Table of Contents

Advertisement

Available languages

Available languages

Speed in 1st gear
Speed in 2nd gear
Maximum torque, 1st gear
Maximum torque, 2nd gear
Diameter, chuck
5
Technical data
For details of the rated voltage, current, frequency and/or input power, please refer to the power tool's
country-specific type identification plate.
When powered by a generator or transformer, the generator or transformer's power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
Weight
5.1
Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
Use only extension cords of a type approved for the application and with conductors of adequate gauge
(cross section). The power tool may otherwise suffer a drop in performance and the extension cord may
overheat.
Check the extension cord for damage at regular intervals.
Replace damaged extension cords.
When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
Recommended minimum conductor cross-section and maximum power-cord length for 120V supply
voltage
Cord
Power-cord length UD 16
Power-cord length UD 30
6

Operation

6.1
Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
6
English
UD 16
900 /min
(15.0 Hz)
2,500 /min
(41.7 Hz)
80 Nm
(59 ftlb
)
f
29 Nm
(21 ftlb
)
f
2 mm ... 13 mm
UD 16
2.6 kg
(5.7 lb)
AWG 16
AWG 14
50 ft
100 ft
50 ft
125 ft
273764
UD 30
1,200 /min
(20.0 Hz)
3,300 /min
(55.0 Hz)
51 Nm
(38 ftlb
)
f
18.5 Nm
(13.6 ftlb
)
f
2 mm ... 13 mm
UD 30
2.5 kg
(5.5 lb)
AWG 12
150 ft
200 ft
*273764*

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ud 30

Table of Contents