Table of Contents
Advertisement
Accessories List
The following accessories are included with TV:
OWNER'S MANUAL× 1
Base Stand × 2
AAA Battery × 2
Screw × 4
NOTE
• The accessories may be different from the list above due to different
models, countries/regions, please refer to the actual accessory bag.
Installation
Installing the Stand
CAUTION
• Be sure to disconnect the A/C power cord before installing a stand
or Wall-Mount brackets.
• The LED display is very fragile, and must be protected at all times
when installing the base stand. Be sure that no hard or sharp
object, or anything that could scratch or damage the LED display,
comes into contact with it. DO NOT exert pressure on the front of
the TV at any time because the screen could crack.
• After the installation is complete, make sure the TV is steady on
a table or firmly attached to a wall mount, before removing all
protective film, if any.
1. Carefully place your TV face-down on a soft, flat surface to
prevent damage to the TV or scratching to the screen.
2. Remove the Base Stand from the accessory bag and then insert
the stands into the bottom slots of the TV.
3. Secure the Base Stand to the TV with the screws in accessory
tightly.
Base stand
Installing the Wall Mount Bracket
Wall mount hole pattern (mm)
Wall mount screw size (mm)
9.5 - 11.5 mm(43
8.0 - 10.0 mm(50
Rear cover of the TV
Follow instructions provided with the wall mount bracket.
NOTES
• The diameter and length of the screws differ depending on the wall
mount bracket model.
• Wall mount bracket is optional, your device may not have wall mount
bracket, please refer to the actual accessories.
Getting started
Remote Control × 1
Base stand
Screws:
M4×16(43
"
) ×4
M4×12(50
"
/55
"
) ×4
"
200×200(43
)
"
"
200×300(50
/55
)
M6
"
)
"
/55
"
)
Wall Mount Bracket
Wall Mount Screw
Wall Mount Spacer
TV Front
Single button (Remote sensor / Power indicator)
Item
Description
Receive remote signals from the remote control.
Remote sensor
Do not put anything near the sensor, as its
function may be affected.
Power
The light is red in standby mode, the light is green
indicator
when TV is on.
Press the single button when in standby mode,
TV will be turned on. Press the single button to
call up the menu, when the focus is on "Power
Off", wait for 3 seconds, then the TV will go into
standby mode automatically.
Standby /
/ Press the single button to call up the menu
Source
and then select among the different input signal
sources.
NOTE
Powering on the TV requires several seconds to load
programmes. Do not rapidly turn the TV off as it may cause the
TV work abnormally.
5
Advertisement
Table of Contents
