Cleaning And Maintenance - Philips FC8776 Important Safety Information

Hide thumbs Also See for FC8776:
Table of Contents

Advertisement

Signal
The start/stop button flashes slowly.
The start/stop button flashes quickly.
The WiFi connection indicator flashes slowly.
The WiFi connection indicator flashes quickly.
The WiFi connection indicator flashes twice briefly
at intervals.
The WiFi connection indicator is solid blue.
The warning indicator lights up.
Clap response
The clap response is enabled when the robot enters sleep mode in the following situations:
- when it stops cleaning due to an error
- when it cannot find its docking station in 20 minutes
If you do not see the robot, you can locate it by clapping your hands once. The robot will respond by
beeping and by lighting up all icons on its display.

Cleaning and maintenance

Emptying and cleaning the dust container
Empty and clean the dust container when the dust container full indicator lights up continuously.
1 Remove the cover (Fig. 24).
2 Pull up the handle of the dust container lid and lift the dust container out of the dust container
compartment (Fig. 25).
Note: When you remove or reinsert the dust container, take care not to damage the blades of the
motor fan.
3 Carefully lift the lid off the dust container (1) and take out the filter (2) (Fig. 26).
4 Shake the dust container over a dustbin to empty it. Clean the filter and the inside of the dust
container with a cloth or a toothbrush with soft bristles. Also clean the suction opening in the
bottom of the dust container (Fig. 27).
Meaning
The robot is charging.
The robot is is searching for the docking station.
The rechargeable battery of the robot is low.
The robot is in WiFi setup mode. The robot does
not yet have connection with the smartphone
and the WiFi router.
The robot is paired with the smartphone but is
not yet connected with the WiFi router.
The robot is connecting with the WiFi router.
The WiFi connection with the robot has been
successfully established.
The robot was lifted while it was cleaning.
A wheel or side brush is stuck.
The bumper of the robot is stuck.
The top cover is not present or is not closed
properly.
The robot cannot find the docking station.
English
13

Advertisement

Table of Contents
loading

Table of Contents