Advertisement
Quick Links
®
Soft Heat
Server
Portable Server with Controlled Heat
1.0 & 1.5 Gallon (Infusion Series
)
®
INSTALLATION & OPERATING GUIDE
For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
Bunn-O-Matic Corporation
Post Office Box 3227, Springfield, Illinois 62708-3227
Phone (217) 529-6601 | Fax (217) 529-6644
www.bunn.com
53431.0001 H 9/21 © 2017 Bunn-O-Matic Corporation
Advertisement
Related Manuals for Bunn Soft Heat Infusion Series
Summary of Contents for Bunn Soft Heat Infusion Series
- Page 1 Portable Server with Controlled Heat 1.0 & 1.5 Gallon (Infusion Series ® INSTALLATION & OPERATING GUIDE For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070. Bunn-O-Matic Corporation Post Office Box 3227, Springfield, Illinois 62708-3227 Phone (217) 529-6601 | Fax (217) 529-6644 www.bunn.com...
- Page 2 AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND. In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages.
-
Page 3: North American Requirements
NORTH AMERICAN REQUIREMENTS • This appliance must be installed in locations where it can be overseen by trained personnel. • For proper operation, this appliance must be installed where the temperature is between 41°F to 95°F (5°C to 35°C). • Appliance shall not be tilted more than 10° for safe operation. •... -
Page 4: User Notices
INTRODUCTION This server allows portable storage and dispensing of up to 1½ gallons of hot beverage at remote locations. Coffee can be brewed directly into the server without removing the cover when used with a BUNN ® INFUSION SH brewers. The spill-resistant design lessens the chance of hot beverage burns and splashes. -
Page 5: Factory Warranty
CLEANING 5. Clean the Inlet Tube with the supplied brush (PN 00674.0000) using the cleaning product solution. 6. Press down on the sight gauge top to release the sight gauge tube. 7. Remove sight gauge tube and bottom seal. 8. Clean the sight gauge tube with the supplied foam brush (PN 57892.0000). - Page 6 CLEANING 11. Using supplied nylon bristle brush (PN 00674.0000) thoroughly scrub the faucet body. 12. Allow the parts to soak in the sanitizer solution for a minimum of five (5) minutes. 13. Remove the faucet parts from the sanitizer solution, and allow to air-dry overnight.
- Page 7 SCHEMATIC WIRING DIAGRAM FOR SH SERVER BLUE LEDs WHITE BLACK GREEN LIQUID PROBE CIRCUIT BOARD BLACK TANK ORANGE TEMP SENSOR BLACK WHITE 72W 24VDC WHITE HEATER BLACK – 24VDC GREEN LIQUID PROBE CIRCUIT BOARD BLACK TANK ORANGE TEMP SENSOR BLACK WHITE 72W 24VDC WHITE...