Asus H110T Manual page 11

System panel connector (10-1 pin PANEL)
This connector supports several chassis-mounted functions.
Speaker connector (4-pin SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker. The
speaker allows you to hear system beeps and warnings.
Display panel VCC power selector (VCC_PWR_SEL)
VCC_PWR_SEL
1
3V 5V
(Default)
LVDS connector
This connector is for an LCD monitor that supports Low-voltage Differential
Signaling (LVDS) interface.
Flat panel display brightness connector (8-pin LCD_BLKT_PANEL)
This connector is for the LCD panel backlight and brightness controls. It enables
the LCD panel backlight, provides backlight control signals, and provides brightness
control signals for the brightness button on the front panel.
Display panel backlight power selector (3-pin BLKT_PWR_SEL)
BLKT_PWR_SEL
12V
(Default)
®
Intel LGA1151 CPU socket
®
Install Intel LGA1151 CPU into this surface mount LGA1151 socket, which is
designed for 6th Generation Intel
processors
For more details, refer to Central Processing Unit (CPU).
Chassis intrusion header (4-1 pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this header. The chassis
intrusion sensor or switch sends a high-level signal to this header when a chassis
component is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
ASUS H110T
3
1 (Default)
2
12V
1-2 (Default)
19V
®
Core™ i7 / i5 / i3, Pentium
Pins Setting
2
3 12V
Pins Setting
2-3
3V
5V
12V
19V
® ®
, and Celeron
1-3