Installation Instructions; Step 1 Remove Packaging And Installation Parts; Step 2 Reversing The Door - Monogram Fresh Food Custom ZIFI240 Installation Instructions Manual

Fresh-food refrigerator bar refrigerator with icemaker
Hide thumbs Also See for Fresh Food Custom ZIFI240:
Table of Contents

Advertisement

STEP 1 REMOVE PACKAGING
AND INSTALLATION PARTS
• Remove corner blocks and foam drawer stops.
• Remove all packing material, tape and protective
plastic coverings.
• Remove the toekick attached to the back of the unit.
• Remove the custom panel attached to the front of
the unit.
WARNING
Small objects are a choke hazard for
children. Remove and discard any parts not used.
AVERTISSEMENT
étrangler les enfants. Il faut jeter toutes les pièces qui
ne sont pas utilisées.

STEP 2 REVERSING THE DOOR

(ZIFI240 model only)
WARNING
Follow all steps when reversing the
door swing. Failure to follow these instructions, leaving
off parts, or over tightening screws, can lead to the door
falling off and result in injury and property damage.
AVERTISSEMENT
inverser le sens d'ouverture de porte. L'omission de
suivre ces instructions, de ne pas utiliser toutes les
pièces, ou le serrage excessif des vis, peuvent causer
la chute de la porte et occasionner des blessures ou
des dommages à la propriété.
• Remove top hinge and discard. Hold the door in
place.
• Remove the black screw-hole cover from top left of
cabinet and insert in top right.
• Remove the top trim cover and discard.
10

Installation Instructions

Les petits objects peuvent
uivez toutes les étapes pour
S
STEP 2 REVERSING THE DOOR
(Cont.)
• Remove 4 screws to remove the top door trim (do
NOT discard).
• Remove the top hinge pin
(do NOT discard).
• Flip the door 180 degrees.
• Remove 3 screws to remove the bottom door trim (do
NOT discard)
• Remove 2 screws to remove the door stop and discard
door stop.
• Remove 1 screw to remove the bottom hinge pin and
discard hinge pin.
NOTE: Make sure the door is upside down so what
was the bottom is now the top.
• Insert the top hinge pin.
• Install top door trim onto the new top side of the door.
• Install the new top trim cover that snaps into place.
• Flip the door 180 degrees.
(ZIFI240 model only)
31-1000642

Advertisement

Table of Contents
loading

Table of Contents