VTech Peppa Pig Play Smart Laptop Instruction Manual page 4

INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the unit. Use a screwdriver to
loosen the screw and then open the battery cover.
3. Remove old batteries by pulling up on one end of each
battery.
4. Install 2 new AA (AM-3/LR6) batteries following the
diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable
batteries are recommended.)
5. Replace the battery cover and tighten the screw to
secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATT ENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
4