Panasonic CZ-RTC6 Installation Instructions Manual page 8

3
Mount the top case.
● Align the claws of the top
case and then align the
claws of the bottom case.
● If the wiring is difficult to
move, loosen the screw in
the lower case, work on the
wiring, then screw in the
screw after finishing the work.
Avoid the
wire being
caught.
Claw (2 places)
2
Connect the remote control wiring.
• Be sure not to allow unnecessary wires to
remain in the remote controller case when
wiring. Be careful not to allow wires to be in
contact with parts on the PCB. For connection
method, refer to "Connection to the remote
controller terminal board" in "Attention".
8
(EN)
Embedded type
1 Mount the bottom case to
the wall.
● Pass the wire through the
wiring hole in the bottom case.
Hole for screw
• Insert the clamper from the
Claw (2 places)
position indicated by the arrow,
Screw
as shown in the diagram at right.
(Supplied)
• Put the locking part of the
clamper in the channel as
indicated by the arrow.
• If you lock at the top, it may not
be possible to close the bottom
case.
*It is also possible to mount in the order
Pass the wire under the rib.
Remove the coating. Approx. 9 mm
● Make sure the wiring connection
is in the correct direction.
2
→
Remote controller
terminal board
Clamper
(supplied)
3
1 → .