Samsung The Premiere LSP7T User Manual page 5

• Do not expose this apparatus to dripping
or splashing.
• Do not dispose of batteries in a fire.
• Batteries (battery pack or batteries
installed) shall not be exposed to
excessive heat such as sunshine, fire or
the like.
• CAUTION: There is danger of an explosion
if you replace the batteries used in the
remote with the wrong type of battery.
Replace only with the same or equivalent
type.
• WARNING - TO PREVENT
THE SPREAD OF FIRE, KEEP
CANDLES AND OTHER ITEMS
WITH OPEN FLAMES AWAY
FROM THIS PRODUCT AT ALL
TIMES.
• Use care when touching the
Projector after it has been on
for some time. Some parts can
be warm to the touch.
Operation
• This apparatus uses batteries. In your
community, there might be environmental
regulations that require you to dispose of
these batteries properly. Please contact
your local authorities for disposal or
recycling information.
• Do not drop or strike the product. If the
product is damaged, disconnect the power
cord and contact a Samsung service
centre.
• When you need to turn off the Projector
completely, wait until the fan stops
completely so that the Project can cool
down completely.
Power
• Do not overload wall outlets, extension
cords, or adaptors beyond their capacity,
since this can result in fire or electric
shock.
• Power-supply cords should be placed so
that they are not likely to be walked on or
pinched by items placed upon or against
them. Pay particular attention to cords at
the plug end, at wall outlets, and at the
point where they exit from the appliance.
• To protect this apparatus from a lightning
storm, or when left unattended and
unused for long periods of time, unplug it
from the wall outlet and disconnect the
antenna or cable system. This will prevent
damage to the set due to lightning and
power line surges.
• Before plugging in the AC power cord
of the Projector, make sure that the
operational voltage of the Projector
matches the voltage of your local
electrical power supply. Refer to the
power specifications section of the
manual and/or the power supply label on
the product for voltage and amperage
information.
• Never insert anything metallic into the
open parts of this apparatus. This may
cause electric shock.
• To avoid electric shock, never touch the
inside of this apparatus. Only a qualified
technician should open this apparatus.
English - 5