DigiTech RPx400 Troubleshooting Manual page 6

Hide thumbs Also See for RPx400:

My mic/line inputs had dropout while I was recording.

• Changing presets while recording will cause dropout of mic and line audio to the

computer.

I can't send or receive MIDI CC data.

• If the system crashed while X Edit was running, then the RPx wouldn't have received

the signal to exit that mode. Go into X Edit and then exit and the cc's should start

working.

What if I plug into a different USB jack on my computer?

• Windows should detect the new hardware and go through a driver installation process

automatically but it will not load the DigiTech USB drivers that you'll need for Pro

Tracks and X Edit. For that, keep the USB cable connected to the new port and run the

USB installer.

I'm adjusting amp type but tone controls keep popping up.

• This happens when MIDI data is echoed back to the unit by Pro Tracks. In Pro Tracks,

go to Options->Project->MIDI Input and set Echo Mode to 'None'.

All manuals and user guides at all-guides.com