Asus 4G-AX56 User Manual page 40

To enable WPS on your wireless network:
1. From the navigation panel, go to Advanced Settings >
Wireless > WPS tab.
2. In the Enable WPS field, move the slider to ON.
3. WPS uses 2.4GHz and 5GHz radio separately.
4. You can use any of the following WPS methods for wireless
connection pairing:
• PBC (Push Button Configuration) Mode:
• Hardware PBC on the router: Press the physical WPS
button on wireless router, and then press WPS button on
wireless client in three (3) minutes.
• Software PBC on the router: Tick <Push button> on WPS
Method field, click Start, and then press the WPS button
on the wireless client in three (3) minutes.
• PIN Code Mode:
• Pairing from the wireless client: Press the WPS button on
the wireless router, and then perform WPS connection
process in PIN code mode and enter the AP PIN Code on
the client device.
• Pairing from the wireless router: Press the WPS button
on wireless client, and then perform the WPS connection
process in PIN code mode and enter the Client PIN Code
on the WPS Method > Client PIN Code filed. Check if
the PIN code is correct and then click Start to pair with
wireless client.
NOTES:
• WPS supports authentication using Open System and WPA2-
Personal. WPS does not support a wireless network that uses a
Shared Key, WPA-Personal, WPA-Enterprise, WPA2-Enterprise, and
RADIUS encryption method.
• Check your wireless device or its user manual for the location of the
WPS button.
• During the WPS process, the wireless router scans for any available
WPS devices. If the wireless router does not find any WPS devices, it
switches to idle mode.
• The router's power LED indicators quickly flash three minutes until
the WPS setup is completed.
40