Casio Exilim EX-Z1000 User Manual page 255

Problem
All buttons and
switches are
disabled.
The camera's
monitor screen is
blank.
I can't transfer
images over a USB
connection.
Display language
setting screen
appears when the
camera is turned on.
C
Possible Causes
Circuit problem caused by electrostatic charge, impact,
etc. while the camera was connected to another device.
USB communication is in progress.
1) The camera is not set securely on the USB cradle.
2) The USB cable is not connected securely.
3) The USB driver is not installed.
4) The camera is turned off.
1) Camera's display language, Home city, date style,
date and time, and other settings have not been
configured.
2) A problem with the camera's built-in memory
management area.
Remove the battery from the camera, reinsert it, and then
try again.
After confirming that the computer is not accessing the
memory card, disconnect the USB cable.
Other
1) Check the connection between the camera and USB
cradle.
2) Check all connections.
3) Install the USB driver (page 210).
4) Press the USB cradle's [USB] button.
1) Check the settings (pages 12, 188).
2) Perform the reset operation to initialize the camera's
setup (page 136). After that, configure each setting. If
the language selection screen does not re-appear
when you turn the camera on, it means that the
camera's built-in memory management area has been
restored. If the same message appears after you turn
power back on, contact your retailer or a CASIO
service center.
255
Action
APPENDIX