Panasonic Lumix DMC-LS60 Operating Instructions Manual page 41

* The fl ash is activated twice. The
1
subject should not move until the
second fl ash is activated.
■ Available fl ash settings by recording
mode
The available fl ash settings depend on the
recording mode.
(○ : Available, — : Not available, ◎ : Initial
setting)
2
*
* It becomes Forced ON [
2
backlight compensation function is
activated.
• The fl ash setting may change when you
change the recording mode. Change the
fl ash setting again if necessary.
• Flash settings are retained even if you
switch the camera off. However, scene
mode fl ash settings return to the factory
settings when you change the scene mode.
Advanced-Shooting
2
*
], when the
■ The available fl ash range to take
pictures
ISO
sensitivity Available fl ash range
(P61)
AUTO 30 cm (0.98 feet) to 4.7 m
(15.42 feet) (Wide)
30 cm (0.98 feet) to 2.6 m
(8.53 feet) (Tele)
ISO100 30 cm (0.98 feet) to 1.8 m
(5.91 feet) (Wide)
30 cm (0.98 feet) to 1.0 m
(3.28 feet) (Tele)
ISO200 40 cm (1.31 feet) to 2.6 m
(8.53 feet) (Wide)
30 cm (0.98 feet) to 1.4 m
(4.59 feet) (Tele)
ISO400 60 cm (1.97 feet) to 3.7 m
(12.14 feet) (Wide)
40 cm (1.31 feet) to 2.1 m
(6.89 feet) (Tele)
ISO800 80 cm (2.62 feet) to 5.3 m
(17.39 feet) (Wide)
60 cm (1.97 feet) to 2.9 m
(9.51 feet) (Tele)
ISO1250 100 cm (3.28 feet) to 5.3 m
(17.39 feet) (Wide)
80 cm (2.62 feet) to 2.9 m
(9.51 feet) (Tele)
• Refer to P107 for the focus range.
• When you use the fl ash when you have
set ISO sensitivity to [AUTO] or set
ISO LIMIT in Intelligent ISO mode [
to anything other than [ISO400], ISO
sensitivity automatically becomes a
maximum of [ISO640] ([ISO400] in the
[BABY1]/[BABY2] or [PET] scene modes
(P47)).
• The edges of the picture may appear
dark if you shoot a very close subject with
the fl ash while the zoom lever is close to
the W side. Zoom in slightly if this occurs.
]
41
VQT1C63