Table of Contents
Advertisement
Only for CQ-DP151W
Remote Control Unit Preparation
E
N
G
L
I
S
Battery Installation
H
1 Remove the battery holder.
1
Pull the holder by the position B while pushing posi-
tion A in the direction indicated by the arrow.
2 Install the battery on the battery holder.
Set a new battery properly with its (i) side facing up
as shown in the figure.
3 Insert the battery holder.
Push in the battery holder back into its original posi-
tion.
Battery Notes
Remove and dispose of an old battery immediately.
Battery Information:
≥ Battery type: Panasonic lithium battery (CR2025) (included)
≥ Battery life:
Approximately 6 months with normal use (at room temperature)
Caution:
≥ Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire.
Battery leakage may damage the unit.
≥ Do not disassemble or short the battery. Do not throw a battery into a fire.
≥ Keep batteries away from children to avoid the risk of accidents.
≥ Be careful to the local disposal rules when you dispose of batteries.
Control Reference Guide
Buttons of the remote control function in the same way as the controls on the main unit of the reference page.
Point the remote control unit at the main unit's sensor (REMOTE).
Power button (PWR)
PWR
(
page 19)
Mode button (MODE)
(
pages 22, 24)
Band button (BAND)
PRG
(
page 22)
Note:
≥ Disc up button (DISC UP) cannot be used in this model.
18
CQ-DP151/DP101W
Lithium battery
(included)
Back side
Battery holder
Position A
(ATT)
Mute button (MUTE)
MUTE
(
page 19)
MODE
Volume control buttons
(VOL, " # )
VOL
(
page 19)
BAND/DISC UP
TUNE
TRACK
Tune/ Track buttons
(TUNE/TRACK, 6 5/% $)
(
pages 22, 25)
Car Audio
Power and Sound Controls
Power
Turn the key in the ignition until the accessory indica-
tor lights.
Power on: Press [SOURCE] (PWR).
Power off: Press [SOURCE] (PWR) again and hold.
Position B
Volume
[" VOL]: Up
[# VOL]: Down
Press and hold for rapid adjustment.
SEL
Mute
Press [MUTE] to mute the sound completely.
MUTE
Press [MUTE] again to cancel.
Anti-volume-blast circuit:
When the power is switched off and on again, the volume slowly rises to the previous level.
The anti-volume-blast circuit will not work when the volume level is set lower than position 20 on the dis-
play.
A C C
Volume level (0 to 40)
CQ-DP151W
CD RECEIVER
BAND
VOL
TUNE
TRACK
DISP
9
10
8
11
7
3
4
1
2
5
MUTE
Remote control signal sensor
Loudness
Press [LOUD] to enhance bass and treble
tones at low or medium volume.
LOUD
Press [LOUD] again to cancel.
E
N
G
L
I
S
H
2
O N
RANDOM
45W
4
X
<
REP
PWR
SOURCE
REMOTE
LOUD
12
6
M/L
19
CQ-DP151/DP101W
Advertisement
Table of Contents
