Table Of Contents; Unpacking The Storage Subsystem - IBM DS3500 Quick Start Manual

Installation overview
The installation of the DS3500 or EXP3500 involves the following procedures:
1. "Unpacking the storage subsystem"
2. "Installing the support rails" on page 4
3. "Removing the storage subsystem or expansion enclosure components" on page 5
4. "Installing the storage subsystem or storage enclosure in the rack cabinet" on page 9
5. "Turning on the power - AC models" on page 11
6. "Installing the software" on page 14
7. "Discovering and setting up the storage subsystem" on page 15
8. "Obtaining information from the IBM Support Web site" on page 16
9. "Updating the storage subsystem firmware" on page 16
10. "Configuring the storage subsystem" on page 16

Unpacking the storage subsystem

Statement 4:
≥ 18 kg (39.7 lb)
CAUTION:
Use safe practices when lifting.
To unpack the storage subsystem or expansion enclosure, complete the following steps:
1. With the help of one other person, remove the storage subsystem or expansion enclosure from the
shipping box and place it on a cart, table, or other raised surface.
2. Check the storage subsystem or expansion enclosure to make sure that you received all the necessary
parts. See the "Inventory list" on page 2 section for the parts that are included with the storage
subsystem or expansion enclosure.
3. Take the left and right support rails and the M5 screws and proceed to "Installing the support rails"
on page 4.
≥ 32 kg (70.5 lb) ≥ 55 kg (121.2 lb)
3