Component Names; Connection Method - Mitsubishi Electric DMC-1000SL-DC User Manual

Item
Conforming
standard
Applicable optical fiber
Compatible connector
Method for connection
Applicable our product model
name
Polishing method of connector
Luminescence center
wavelength
Light reception wavelength
Light emission level
Light reception level
Permissible loss
Target transmission distance
Series connection
PWR LED
OPT LINK LED
*2 Our Company prepares various optical fiber cables that suit 1000BASE-SX standard.
*3 Please contact us.
*4 15km are applicable between these products (DMC-1000SL-DC). In case connecting with 1000BASE-LX
compatible unit, the distance is 5km (max.).

◆ Component Names

(Front face)

◆ Connection Method

Use this product as following.
1) Connect OPT1 port with another DMC-1000SL-DC or a 1000BASE-LX compatible unit by a single
mode optical cable.
2) Connect OPT2 port with a 1000BASE-SX compatible unit by a multi-mode optical cable.
3) Check the connection of optical fiber cables to OPT port
4) Wire power supply terminal block with power supply cables and a FG cable. Then turn on the DC24V
power supply.
5) OPT1 and OPT2 LINK LED go on if PWR LED light is turned on, and all of modules communicate well.
(Cover unused ports with the dust caps belonging this product.)
Table 3.3 Performance specifications
OPT1 port
IEEE802.3z Gigabit Ethernet
(1000BASE-LX)
1000BASE-LX compatible
single-mode optical fiber cable
Duplex LC connector (IEC61754-20)
- *3
PC, SPC, AdPC, UPC polish
1270～1360nm
1100～1600nm
-10.0dBm～-3.0dBm
-3.0dBm～-20.0dBm
10dB
15 km (max.) *4
Light during single-mode
optical signal reception
OPT1 port
OPT2 port
Power supply
terminal block
Figure 4.1 Names of parts
- 4 -
IEEE802.3z Gigabit Ethernet
(1000BASE-SX)
1000BASE-SX compatible
multi-mode optical fiber cable *2
Core/cladding：50/125μm
(Band: 500 MHz・km or higher, =850 nm)
Crossing(A to B , B to A)
PC, SPC polish
830～860nm
770～860nm
-9.5dBm～-1.5dBm
-1.5dBm～-17.0dBm
550 m (max.)
4 (max.)
Lights when power is on
Light during multi-mode
optical signal reception
(Top face)
(Side face)
OPT2 port
QG series
7.5dB
Screw hole
for mounting plate
*The bottom is
same as the top.
DIN rail
Attachment
Serial number
plate