Table of Contents
Advertisement
IMPORTANT!
It is essential that you read the
instructions in this manual before
assembling, operating, and maintaining
the product.
Subject to technical modifications.
Safety, performance, and dependability
have been given top priority in the design
of your lantern.
INTENDED USE
The lantern is intended for general
illumination. Do not use the product in
wet conditions.
Do not use the product for any other
purpose.
Use
of
operations different from intended could
result in a hazardous situation.
LANTERN SAFETY WARNINGS
■
The light source of this luminaire
is not replaceable. When the light
source reaches its end of life the
whole luminaire shall be replaced.
■
Use only with recommended battery
pack and charger. Any attempt to
use another battery pack will cause
damage to the product and could
possibly explode, cause a fire, or
personal injury.
■
Do not disassemble the product.
■
If wrapped or in contact with fabrics,
the lens can produce sufficient heat
to melt some fabrics. To avoid serious
personal injury, never allow the lens
to come in contact with anything.
■
Do not place the product or battery
pack near fire or heat. This will
reduce the risk of explosion and
possible injury.
■
Remove the battery pack before
2
Original Instructions
the
product
for
starting any work on the product.
■
Do not store the product in a damp
or wet location, or in a location where
the temperature may reach or exceed
40°C. For example, inside sheds,
vehicles, or metal buildings in the
summer.
BATTERY SAFETY WARNINGS
■
To reduce the risk of fire, personal
injury, and product damage due to
a short circuit, never immerse your
tool, battery pack or charger in fluid
or allow a fluid to flow inside them.
Corrosive
or
such as seawater, certain industrial
chemicals, and bleach or bleach-
containing products, etc., can cause
a short circuit.
TRANSPORTING LITHIUM BATTER-
IES
Transport the battery in accordance
with local and national provisions and
regulations.
Follow
all
special
on
packaging
and
transporting batteries by a third party.
Ensure that no batteries can come in
contact with other batteries or conductive
materials while in transport by protecting
exposed connectors with insulating, non-
conductive caps or tape. Do not transport
batteries that are cracked or leaking.
Check with the forwarding company for
further advice.
MAINTENANCE
■
Use only original accessories and
spare parts. Should components
need to be replaced which have
not been described, please contact
an authorised service centre. All
repairs should be performed by an
conductive
fluids,
requirements
labelling
when
Advertisement
Table of Contents
