Table of Contents
Advertisement
3.3.8
NVMe Configuration
This menu displays the NVMe controller and Drive information of the connected
devices.
3.3.9
Power Management
Power Mode [ATX Type]
Select power supply mode. Configuration options: [ATX Type] [AT Type]
Ensure to power off the system before switching between ATX and AT type.
Restore AC Power Loss [Last State]
[Last State]
The system goes into either off or on state, whatever the system
state was.
[Always On]
The system goes into on state after an AC power loss.
[Always Off]
The system goes into off state after an AC power loss.
RI Wake Event [Disabled]
Enable or disable system to wake up from RI#. Configuration options: [Enabled]
[Disabled]
RTC Wake system from S5 [Disabled]
[Disabled]
[Fixed Time]
[Dynamic Time]
The following items appear when Fixed Time is enabled.
3.3.10
Digital IO Port Configuration
The items listed in this screen configure Digital IO settings.
DIO Port1~Port4 [Output], DIO Port5~Port8 [Input]
Configuration options: [Input] [Output]
The following item appears only when you set DIO Port1~8 to [Output].
Output Level [High]
Configuration options: [Low] [High]
3.4
Chipset menu
Chapter 3: BIOS Setup
Disables system wake up from S5.
The system will wake up at the specified hr::min::sec.
Configuration options: [Disabled] [Enabled] .
The system will wake up at the current time plus a specified
number of minutes.
3-7
Advertisement
Table of Contents
