hp
StorageWorks
Caution: Parts can be damaged by
electrostatic discharge. Keep parts in their
containers until needed. Ensure you are
properly grounded when touching static-
sensitive components.
1
Inspect the contents of the kit.
Removal
3
Identify the
e2400-160
interface
controller to
be replaced.
It is located in
one of the top
6 slots of the
card cage. When the power is on, the ACT/LNK
LEDs will be off instead of green; the power LED
might also be off. You may need to find out
which drives are connected to each controller to
identify the controller to replace.
ESL E-Series
e2400-160
Interface
Controller
Replacement
Note: This part is not hot-pluggable.
It is necessary to power down the library
to replace this part.
2
Open the back door of the library.
4
Power off the library.
Use your backup software to empty the picker
a.
or to verify that the picker is empty.
Place the library off-line by pressing the
b.
Standby button on the library's front panel.
Verify that the front panel display indicates
c.
"System Off-line".
Press and hold the power button, located on
d.
the front of the library behind the laptop tray,
until the front panel goes blank.