•
SRS - the leading 3D sound technology in the world, which restores
the spatial information that is masked by traditional recording and
playback techniques.
•
TruBass - SRS technology that enhances bass performance by uti-
lizing psychoacoustic techniques to restore the perception of low fre-
quency tones, delivering deep rich bass to your i830 internal
speakers or optional headphones.
•
Focus - Elevates the sound image field to create the perception of
image height. When used in combination with SRS 3D, it delivers an
enlarged sound image while improving the clarity in the high fre-
quencies in your audio.
CarKit Volume
The CarKit Volume determines the volume settings for voice
and PDA ringers when yo u r i830 is attached to the optional
hands‐free kit installed in a vehicle.
Volume settings range from Silent to Loud. To set each option
for the optional CarKit, follow these steps:
1. Tap Start located in the upper left corner of the screen.
2. Tap Settings.
3. Tap the System tab.
4. Tap CarKit Volume.
5. Using the stylus, tap the desired level on the slider for each of
the volume settings available.
6. Tap
to save your settings and exit.
Sounds and Notifications
The Sounds and Notifications settings allows you to select the
actions for which you hear sounds and to customize how you
notified when different events occur.
56
Section 8: Changing Your Settings
Turn volume off
You can turn the ringer off, or you can select one of the other
Ring tone options, such as Vibrate, Vibrate and ring, or Vibrate
then ring.
1. Tap Start located in the upper left corner of the screen.
2. Tap Settings, then tap the Personal tab.
3. Tap Phone.
4. Tap the drop down arrow next to Ring type and select one of
the Vibrate options or select None.
5. Tap
to exit.
Password Setting
The password option allows you to enable or disable a
password. The available settings are:
•
Simple 4-digit password - Allows you to set a four digit password
using the on-screen keypad.
•
Strong alphanumeric password - Allows you to enter a password
that contains letters, numbers, or both.
When a password is configured, there is a ʺprompt if device
unusedʺ option that allows a length of time range from 0
minutes ‐ 24 hours. When this option is set, you can continue to
use the i830 until the screen turns off due to inactivity. If the
device is inactive for a greater amount of time than specified in
this setting, a password must be entered when you turn the
device back on.
Phone Settings
Phone options are divided into the following tabs:
•
Phone
- Use Phone Mode to set your phone for the operational
mode of Verizon (CDMA) or Int'l (GSM).
•
Option
- Allows you to configure the SMS Call Back Number, as
well as the Answer options for your phone.
Section 8: Changing Your Settings
Password Setting
57