Armlift Height - Technics SL-100C Operating Instructions Manual

3
After arm height adjustment is
finished, lock the tone arm by
turning the arm lock knob.
 Be sure to turn the arm lock knob to the
end as shown in the figure below. You
may need to apply some force to do so.
Attention
 Be careful not to damage the stylus tip.
 Do not use the product with the arm lock
released.
 For finer adjustment, use a level (not included)
to adjust the arm height so that the cartridge
becomes parallel to a record.

Armlift height

Make an adjustment according to your
cartridge if necessary.
Preparation
 Put a record on the turntable.
 Remove the stylus cover ( 18), taking care
not to damage the stylus, then release the
arm clamp.
 Lift the cue lever and move the tone arm over
the record.
1
Check the armlift height (distance
between the stylus tip and record
surface).
If adjustment is needed, go to
step 2 .
 The armlift height is factory-adjusted to
8 to 13 mm.
2
Return the tone arm to the arm
rest, clamp it with the arm clamp
and while pressing the armlift
down with your finger, turn the
screw to adjust the height.
 Turning the screw clockwise lowers the
armlift.
 Turning the screw anti-clockwise raises
the armlift.
Armlift
Armlift screw
Arm clamp
17 17