Multitech MultiConnect MTS2SA-T User Manual page 30

Command Syntax
Description
Default Value
Success
Error
Command Syntax
Description
Default Value
Success
Error
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
set serial [s0] auto-dialin-port [port_num]
Command to specify the auto dial-in port number.
Note: [port_num] is optional here. If port_num is not specified, the standard
port 23 of the Telnet protocol shall be used.
This command is valid only for device port S0
23
OK
1. Too few arguments
"Usage: set serial s0 auto-dialin-port [port_num]
Type 'set serial s0 auto-dialin-port ? for more information"
2. Multiple matches
auto-dialin
auto-dialin-ipaddress
auto-dialin-port
3. Invalid port
"error: Invalid port number
Type 'set serial s0 auto-dialin-port ? for more information"
4. If "set serial s1 auto-dialin-port 23" is given
"error: Command not supported on modem port s1"
set serial [s0] auto-dialin-protocol <telnet>
By default, Telnet is the protocol used to establish the serial-to-Internet
connectivity.
Note: This syntax provides for future extensibility (SSH Client, etc.)
This command is valid only for device port S0<ftp protocol setting is not yet
implemented>
Telnet
OK
1. Too few arguments
"Usage: set serial s0 auto-dialin-protocol <telnet/ftp>
Type 'set serial s0 auto-dialin-protocol ? for more information"
2. Multiple matches
auto-dialin
auto-dialin-ipaddress
auto-dialin-port
3. Invalid protocol selected
"error: Selected protocol not supported
Type 'set serial s0 auto-dialin-protocol ? for more information"
4. If "set serial s1 auto-dialin-protocol telnet" is given
"error: Command not supported on modem port s1"
Chapter 4 – Command Line Interface (CLI)
Serial Commands – Setup
auto-dialin-protocol
auto-dialout
auto-dialout-port
auto-dialin-protocol
auto-dialout
auto-dialout-port
auto-dialout-protocol
auto-dialout-protocol
30