Table of Contents
Advertisement
PAN9028 Bluetooth/Wi-Fi Module
The antenna requires a cutout area of 8 mm × 5 mm under the PAN9028 module. This "Keep
out Area" shall be located in every layer under the module antenna. Note for example the "Keep
out Area" in all four layers of the PAN9028 evaluation board.
It is recommended to verify the perfect position of the module in the target application before
fixing the design.
Antenna Placement Recommendation
All dimensions are in millimeters.
Use a ground plane in the area surrounding the module wherever possible.
It is recommended to place the module:
•
In the center (horizontal) of mother PCB.
•
At the edge (horizontal) of mother PCB.
Module Integration Guide Rev. 1.0
Top View
12.00
Min. 15.00
3.00
8.00
„Keep out Area"
PAN9028
3 PAN9028 Module
Min. 15.00
1.00
Page 13 of 34
Advertisement
Table of Contents
