TABLE OF CONTENTS 1. FEATURES 2. PRECAUTIONS Installation 3. CONTROLS 4. OPERATIONS Setting system volume Adjusting the controls Setting the low-pass frequency Connecting an MP3 player or video unit Care and maintenance 5. INSTALLATION AND WIRING What's in the Box Before starting Tools and additional components Mounting Diagram...
FEATURES PYLE PLXREQ710P is a 7-band stereo equalizer/crossover speci cally created for the mobile environment. The PLXREQ710P provides powerful features in a compact size: • Seven equalization bands( 50Hz, 125Hz, 315Hz, 2.2KHz, 6KHz, and 16kHz), each frequency adjustable from -12 to +12dB (-15 to +15dB for subwoofer frequencies) •...
PRECAUTIONS • Do not operate this product in ways other than those described in this manual. • Do not disassemble or modify this unit. • Do not pour liquid or poke foreign objects into the unit. Water and humidity may damage internal circuitry. •...
CONTROLS AUX(auxiliary)switch: Press to select auxiliary or main inputs Subwoofer volume Equalizer gain controls To adjust gain, rotate control to desired setting Master volume Fader control: Use to balance sound between front and rear speakers - Front panel controls - - Rear panel connections - Low-pass frequency switch (60 / 90Hz)
Set it so most of the music comes from the front and only lls the rear. Setting the low-pass frequency Set the low pass frequency switch on the top of the PLXREQ710P to either 60Hz or 90Hz depending on the subwoofer and subwoofer ampli er requirements.
2. Make sure the auxiliary button on the front of the unit is out, ready to receive input from the main RCA input (not the auxiliary RCA input). 3. Turn the PLXREQ710P master volume to a normal listening level. 4. Press the play button on the auxiliary source.
Power Red Wire with 1A Fuse Before Starting Mounting Precautions The PLXREQ710P can be mounted next to the source unit or under the dash using the mounting brackets. The front panel controls should be easily accessible from the driver's seat.
Tools and additional components You will need: • A Philips-head screwdriver when mounting the unit in the vehicle. • A small at-head screwdriver to adjust the AUX gain controls if you connect an MP3 player or video source. • High-quality RCA input and output cables. Extra cable can cause signal loss and act as an antenna for noise.
Troubleshooting The unit does not work: No lights The power wires may not be connected. Check the power and ground wiring, then retest. Sound is Distorted • The source unit volume may be set too high. Reduce the source unit volume. •...
Speci cations Features: • 7 Band Parametric Equalizer • Half Din Size • 7 Volt RMS Pre-Amp Output • Pre-amp Line Aux Inputs Via RCA Jacks • 3 Input Sources Selectable • Input Gain Adjustments • RCA AUX Input Jack •...