Table of Contents
Advertisement
Adjusting the installation angle (continued)
■ If the picture is tilted to the left or right
Range of
adjustment
± 5°
Loosen two captive
washer hex head bolts
each at the front and rear.
Attention
z After checking the position adjustments, check that the screws have been tightened to the torques specified on
page 9.
Note
z If there is a keystone effect in the image even after adjusting the installation angle in the [POSITION] menu
of the projector without applying keystone correction, the positional relationship between the screen and the
projector is out of alignment. Check that the screen and projector are aligned opposite each other. Alternatively,
perform the keystone correction at the projector.
Specifications
Height (from center of projector
lens to ceiling)
Range of
Horizontal swing angle
adjustment
Vertical tilt angle
Horizontal tilt angle
External dimensions
Weight
z Adjust to the position where the picture is not tilted
by loosening the captive washer hex bolts fixing the
projector mounting bracket and the angle adjusting
bracket (two locations in front and rear), and
rotating the projector.
z Once the picture position has been set, be sure to
retighten the bolts securely.
Adjustable span
Attention
z Do not over-loosen the captive washer hex head
bolts, which are used to secure the adjustable
bracket to the projector mounting bracket.
Otherwise, the projector may fall off.
949 mm - 1 429 mm (37-3/8" - 56-1/4")
Height: 1 054 mm - 1 534 mm (41-1/2" - 60-13/32"),
±1.2°
±3°
±5°
Width: 344 mm (13-17/32"),
Depth: 303 mm (11-15/16")
Approx. 13.5 kg (29.8 lbs.)
ENGLISH - 19
Advertisement
Table of Contents
