Notes On Measurements; Safety Notes - Minolta Pulsox-2 Instruction Manual

This finger holder is designed only for use on the fingers of adults,
so it should not be used on any other body parts.
Never secure the finger holder with tape or such like. Doing so
may cause hemostasia or dropsy.
Notes on Use
• Remove nail polish before taking measurements.
• If no measurement values are displayed, attach the finger holder to a
thinner finger to take measurements.
• It may not be possible to take measurements in case of blood circulation
or blood stream problems. In this case, remove the finger holder, rub or
warm the finger to improve blood circulation, then re-attach the finger
holder.
• Do not use the instrument in areas where it is exposed to strong light
such as direct sunlight.

Notes on Measurements

• Check that the pulse level meter changes in synchronization with the pulse
rate during measurements. In the following cases, the level meter may
not operate properly, hindering display of correct values.
• Rapid body movement
• Finger Holder is not attached to the patient properly.
• Arm or finger is pressed, causing bad blood circulation.
• When using the instrument, take care not to expose the finger holder to
strong light.

Safety Notes

11