Instructions For Handling - Hisense AVC-05HJFA Operation Installation Maintenance Manual

Do not perform installation work, refrigerant piping
work, drain piping and electrical wiring connection
without referring to the installation manual.
Check that the ground wire is securely connected.
Connect a fuse of specified capacity.
No.
Handsaw
1
Screwdriver
2
Vacuum Pump
3
Refrigerant Gas Hose
4
Megohmmeter
5
Copper Pipe Bender
6
Water Pump
7
Pipe Cutter
8
Brazing Kit
9
Hexagon Wrench
10
Note: When in immediate contact with refrigerant, please use the installation tools and instruments dedicated to the new refrigerant.
Since the pressure of new refrigerant R410A is 1.4 times that of traditional refrigerant, its performance is
susceptible to impurities like moisture, scale and grease, etc. It's essential to remove the moisture, dust, other
refrigerants or refrigerant oils from the refrigeration system. Hence, the failure to use specified materials and
tools may result in explosion, personal injury, refrigerant leakage, electrical failure or fire.
3.1 Transportation
Transport the product as close to the installation
location as practical before unpacking.
Do not put any material on the product.

3.2 Instructions for Handling

Do not put any foreign material into the indoor unit
and check to ensure that none exists in the indoor
unit before the installation and test run. Otherwise, a
fire or failure, etc. may occur.
Be careful not to cause damage to insulation
materials of the unit surface when it's lifted.
Tool
Do not install the indoor unit, outdoor unit,
remote control switch and cable
within approximately 3 meters from strong
electromagnetic wave radiators such as
medical equipment.
No.
Spanner
11
Charging Cylinder
12
Multi-purpose Measuring Instrument
13
Cutter for Wires
14
Gas Leak Detector
15
Leveller
16
Clamper for Solderless Terminals
17
18
Hoist (for Indoor Unit)
19
Ammeter
20
Voltage Meter
Install the indoor unit as per national standard
Do not install the indoor unit in a flammable
environment since this may cause fire or an explosion.
Do not install the indoor unit outdoors. If installed
outdoors, an electric hazard or electric leakage will
occur.
4.1 Factory-Supplied Accessories
Check to ensure that the following accessories are
packed with indoor unit.
Please refer to the packing list on the end page of
this manual for standard accessories.
If any of these accessories are not packed with the
unit, please contact your dealer.
1
Tool