Parameter Change - JVC XP-A1010TN Service Manual

3.5 FIDAP-R/DAP balance
3.5.a
Push the MAIN MUTE but-
siseitlone ton (8) to mute the main
signal.
3.5.b
Save Push the R/DAP MUTE but-
Cod pvpap Level ton 49 again to release
' muting.
3.5.c Adjust the R/DAP level to be balanced with the FIDAP
level.
[On the remote control unit]
Down
RIDAP LEVEL [ or
{On the main set}
own
a
then aw or
Each time the button is pushed, the level is reduced
or increased. Keep pushing it to continuously change
the tevel.
R/OAP.
LEVEL
O
+,
EL-L (LOS "ON)
3.6 Release muting
waver Push the MAIN MUTE. button
@® to release muting.
3.7 Adjust the total level
[On the main set]
Rotate the MASTER VOLUME
o i total fevel.
- MUTED @ to adjust the
(
MIN MAX
or
[On the remote control unit]
Down
MASTER VOLUME or
—23—
PARAMETER CHANGE
The programs contain the various data for sound-field reproduction based on the data collected in the performance places
using the symmetrical 6-point sound-field analyzing method. You can create your own original sound-field reproduction pattern
by changing the parameters and then saving the new sound-field pattern in a manual-memory location.
1. Selecting a program
Select a program according to the "How To use
PROGRAMED PRESET". (P. 18)(ex. program 3)
Symphony Hall 3
Shoebox Tyre
Mo iSymehony Hall &
LFF = GkHz
Each time the button is pushed, the value is reduced or
increased by one unit. Keep pushing it to continuously
change the value.
4, Change each parameter by repeating Steps 2 and 3
2. Selecting parameters
[On the remote control unit] [On the main set]
PARAMETER PARAMETER
x3 x3
LPF: 7 kHz
Push the PARAMETER buttons @ or ©) to select
the parameters to be changed.
ymphony Hall & ¥
P
3. Changing parameters
[On the remote control unit}
- +
[ ; : or [ °
Push the '—" or "+" button ©) to set the
parameter's vatue.
[On the main set]
DOWN up
yw as
Ave
\
Push the DOWN v @ or UP A @ button to set the
parameter's value.
— 24 —
See P.6 for definitions of the parameter values.
Changed parameters return to the programed value when
another program is loaded if it is not stored in manual
memory.
Using the manual memory procedure, store the changed
parameters in manual memory to save your new original
sound: field program.
N.LOLOLW