Reversing The Door Hinge - commercial cool CCB51GB User Manual

SET UP & USE
PROTECTION FROM HEAT AND MOISTURE
• Do not install your Beverage Cooler in any location where heavy
moisture is present or if the location is not properly insulated. This
Beverage Cooler is not designed to operate in temperature settings
below 55° Fahrenheit.
• Location for the Beverage Cooler should be on a hard surface and
away from direct sunlight and heat source, e.g., radiators, baseboard
heaters, cooking appliances, etc.

REVERSING THE DOOR HINGE

(MODEL CCB51GB & CCB81GB)
1. Remove the top hinge cover.
2. Using a Phillips Head Screwdriver, loosen and remove the 2 screws
holding the top hinge in place.
3. Remove top hinge and carefully lift off the door.
4. Remove the screw hole plugs from the opposite side of the cabinet
and the door and insert the plugs in the screw hole openings of the
just removed screws.
5. Remove any loose items in the Beverage Cooler.
NOTE: Do not tilt the appliance over 45 degrees when reversing the
door as possible damage to the sealed system may occur.
6. Remove Left & Right Leveling Feet from underside of Cooler.
7. Loosen the screws holding the lower hinge bracket to the Beverage
Cooler and remove screws and bracket.
8. Remove the door pin from the lower hinge bracket by turning it
counterclockwise.
9. Remove (2) screws from the opposite side of the Cooler and insert
these screws into the previously removed screw holes. Tighten the
screws.
10. Flip the lower bracket over and then reinsert the door pin into the
threaded hole and tighten.
11. Align the door with the cabinet first. Then install the lower hinge
bracket to your desired side of the cabinet. Make sure door is resting
on door pin of the lower bracket. Then insert (2) remaining screws
into the holes. Tighten the screws.
12. Align top hinge bracket with screw holes, insert screws and partially
secure, check that door and cabinet are properly aligned and then
secure tightly.
Page 10