Table of Contents
Advertisement
Tips for saving energy
1.
Install the appliance in a cool, well ventilated room, but not in direct sunlight and not near a heat source
(radiator, cooker.. etc). Otherwise use an insulating plate.
2.
Allow warm food and drinks to cool down outside the appliance.
3.
When thawing frozen food, place it in the refrigerator compartment. The low temperature of the frozen
food will help to cool the refrigerator compartment when it is thawing. This will help to save energy. If the
frozen food is put out, it results in a waste of energy.
4.
Cover drinks or other liquids when placing them in the appliance Otherwise humidity increases in the ap-
pliance. Therefore, the working time gets longer. Also covering drinks and other liquids helps to preserve
smell and taste.
5.
Try to avoid keeping the doors open for long periods or opening the doors too frequently as warm air will
enter the cabinet and cause the compressor to switch on unnecessarily often.
6.
Keep the covers of the diff erent temperature compartments (crisper, chiller ...etc ) closed
7.
Door gasket must be clean and pliable. Replace gaskets if worn.
8.
Energy consumption of your appliance is declared without drawers and fully loaded in freezer compart-
mant.
9.
For saving energy, do not use volume between the load limit and the door, along the load limit line. Load
limit line is also used in energy consumption declaration.
Load limit line label
Copyright © 2018, Fast ČR, a. s.
EN - 19
Revision 06/2018
Advertisement
Table of Contents
