Table of Contents
Advertisement
en operation
¡ The setting is saved if you activate
or deactivate the intelligent dosing
system.
13.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme is set.
→ "Setting a programme", Page 31
¡ The programme settings have
been adjusted.
→ "Adjusting the programme set-
tings", Page 31
Press and hold
▶
seconds.
Press
to call up the saved pro-
gramme.
Note: To overwrite the saved pro-
gramme, repeat the steps above.
13.5 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 26
Requirement: The laundry is pre-
pared.
→ "Laundry", Page 30
Open the door.
1.
Ensure that the drum is empty.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
32
for approx. 3
13.6 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 31.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 18
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.7 Starting the programme
Requirement: A programme has
been set.
→ "Setting a programme", Page 31
Press
.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.The display shows either the
programme duration or the "Ready
in" time.
a After the programme has ended,
the display shows: End.
Advertisement
Table of Contents
