Advertisement
IM Installation
With all of the AR installation options, it is recommended that the IM is mounted/
installed below deck.
To install the IM:
1.
Open the IM enclosure by unscrewing the two IM Enclosure Screws
on the front panel
2.
Insert the male RJ45
connector on the end
of the AR Interconnect
Cable into the female
RJ45 connector in the
middle of the inside of
the IM enclosure. The
RJ45 connector will
click into place when it
is connected correctly
3.
Route the AR Intercon-
nect Cable through the
exit slot of the IM en-
closure (between the
other two cables) and close the IM
4.
Re-insert and tighten IM Enclosure Screws (from Step 1) on the IM
cover
5.
Mount the IM with the IM Mounting Screws provided, on a vertical
surface, with the cables exiting downwards
6.
Connect the IM Power Cable to the vessel's power (8 to 16 VDC
source)
7.
Connect the IM Network Cable to the Chartplotter
6
Advertisement
