Pace Technologies TERAPRESS TP-7001 Quick Start Manual

TERAPRESS TP-7001 Use & Safety
Safety Notes
!
Caution: SYSTEM USE PRESSURE AND HIGH TEMPERATURE
!
Caution: DO NOT POSITION HEAD OR OTHER BODY PARTS OVER THE MOLD WHEN
RAISING THE RAM TO REMOVE THE SPECIMEN MOUNT
!
During operation, the closure and upper parts of the heating and cooling block can get very hot. For
safety, do not touch the closure unit. Use protective gloves if required.
!
Always completely screw tighten the bayonet cover and back off a fraction so it is not too tight.
Improper installation can result in hot molten mounting material leaking (danger of burning).
Initial cooling water coming into contact with mold will produce an initial burst of steam. To avoid
!
danger of burning, secure the drain line and use caution when the TERAPRESS TP-7001
compression mounting press is in use.
!
Mold cylinder and ram get very hot during the mounting process. Take care before changing
(danger of burning).
!
Mounting samples must be chemically compatible with the mounting material. Do not mount
flammable samples.
!
Before opening the unit, disconnect main power plug. Replacement parts should be installed only
by qualified personnel.
!
Follow proper operating instructions (See opposite page) and obtain proper training before
operation.
!
Do not leave press unattended during operation.
!
Turn-off external water supply when press is not in operation.
!
If bayonet cover is difficult to remove, verify that the lower ram has been lowered. If bayonet cover
is still hard to remove, do not force. Call for service.
!
If sample does not eject properly or is sticking, discontinue use immediately and call for service.