Do Not Disturb - Start Up Tone; Speaker System Options - Cable Mode; Speaker System Options - Inverse L/R Speakers; Power Mode - KEF LS60 Wireless User Manual

16.7.4 Do Not Disturb – Start Up tone
This setting enables the start up tone to be muted when the speakers are turned on.
16.7.5 Speaker System Options – Cable Mode
You can connect the Primary Speaker and Secondary Speaker with the provided inter-
speaker cable through the "T" connection ports on the back panels of the speakers.
Once the cable is connected, enable this setting to enable Cable mode and disable the
wireless connection.
Cable Mode is required/recommended when:
• You prefer a higher resolution at 192 kHz/24 bit (wireless: 96 kHz/24 bit).
• You are experiencing audio dropouts due to interference.
16.7.6 Speaker System Options – Inverse L/R Speakers
This setting changes which speaker plays left and right. By default, the Primary Speaker
plays the right channel.
16.7.7 KW-1 Power Mode
This setting switches the USB port of the Primary Speaker from audio input to power
output. Turn on this setting to enable the KW-1 transmitter to be power by the
speakers. Note that USB audio input will be disabled when this setting is turned on.
74