Table of Contents
Advertisement
Available languages
Available languages
Dimensions:
Approx. 270 mm × 60 mm × 215 mm (10
2
3
/
in × 8
1
/
in) (w/h/d)
8
2
270 mm (10
3
/
in)
4
220 mm (8
3
/
in)
4
215 mm (8
1
/
in)
2
196 mm (7
3
/
in)
4
60 mm (2
3
/
in)
8
Mass:
Approx. 2.9 kg (6 lb 7 oz) not incl. accessories
Package contents:
Main unit (1)
Bass remote (1)
Parts for installation and connection (1 set)
Design and specifications are subject to change
without notice.
16
GB
Troubleshooting
3
/
in ×
4
The following checklist will assist in the correction
of most of the problems you may encounter with
your unit. Please refer to the connection and
operating procedures before going through the
checklist below.
The status indicator light does not light up.
The fuse is blown.
Replace the fuse with a new one.
The ground (earth) lead is not securely
connected.
Fasten the ground (earth) lead securely to a
metal point on the car chassis.
The voltage going into the remote input
(REMOTE) terminal is too low.
Turn on the car audio unit if it is not turned on.
Use a relay if the system employs too many
amplifiers.
Check the battery voltage (10.5 V – 16 V).
The status indicator light changes from white to
red.
Turn off the amplifier. The speaker outputs have
shorted.
Rectify the cause of the short.
Turn off the amplifier. Make sure the speaker lead
and ground (earth) lead are securely connected.
The amplifier becomes abnormally hot.
The amplifier heats up abnormally.
Use speakers with suitable impedance: 2 Ω –
8 Ω.
Make sure to place the amplifier in a well
ventilated location.
The sound is interrupted.
The thermal protector has activated.
Reduce the volume.
Alternator noise is heard.
The power connecting leads are installed too
close to the RCA pin cables.
Keep the leads away from the cables.
The ground (earth) lead is not securely
connected.
Fasten the ground (earth) lead securely to a
metal point of the car.
Negative speaker wires are touching the car
chassis.
Keep the wires away from the car chassis.
The sound is too quiet.
The INPUT SENS control setting is not
appropriate. Turn the INPUT SENS control in the
clockwise direction.
If these solutions do not help improve the situation,
consult your nearest Sony dealer.
Advertisement
Chapters
Table of Contents
