Table of Contents
Advertisement
Provisioning
R
/LED T
ESET
EST
A soft reset re-initializes the module software and clears the error registers shown on the HDSL4 Performance
Monitoring Reports.
Performing a reset is a non-service affecting software routine. However, if the Reset command
is assigned to security Level 5 through the System Administration Menu Security screen and
the user is assigned to a Level 4 or below, the user cannot execute this command. (For more
information on editing menu security, refer to the shelf controller unit documentation listed
under Related Publications at the beginning of this manual.)
Performing a reset logs the user off.
To reset the H4LXC:
1
From the SCU Main Menu, use the arrow keys or number keys to select
6. System Maintenance. Press
System Maintenance menu appears (see
2
From the System Maintenance menu, select 2. Reset/LED Test
Commands. The Reset/LED Test screen appears as shown in
3
Use the arrow keys to select the module to be reset. Press
(the confirmation query shown in
module reset.
24
C
OMMANDS
if using the arrow keys. The
ENTER
Figure 15 on page
Figure 17
appears). Press
Figure 17. Reset/LED Test Screen
December 3, 2003
6. System Maintenance
23).
2. Reset/LED Test
Figure
17.
Commands
to execute
R
to reset the module; press
Y
LTPS-UM-8054-01
to cancel the
N
LPS-H4TU-C-L5
Advertisement
Table of Contents
