Honeywell 50616 User Manual page 8

FINAL INSTALLATION
4. Insert each blade through a slot in the the side of the motor assembly. Align the holes of the blade with the holes in the blade
arm. Secure each blade with the three blade screws and blade washers (Figure 5.4).
5. Remove one of the three fitter plate screws from the fitter plate and loosen the other two. Then, insert the wires from the fan
through the hole in the light pan. Attach the light pan to the fitter plate by twisting the light pan clockwise until the loosened
fitter plate screws engage the key slots on fitter plate. Re-install the third fitter plate screw into the open hole in the light pan
and securely tighten all three fitter plate screws (Figure 5.5).
6. Remove one of the light pan screws and loosen the other two. Then, connect the 9-pin connector from the fan to the 9-pin
connector from the light kit. (Figure 5.6).
7. Place the keyholes of the light kit over the light pan screws and turn clockwise. Secure the light kit with the remaining previously
removed light pan screw. Tighten all three light pan screws (Figure 5.7).
8. Attach the glass bowl to the light kit by twisting the glass bowl tightly in a clockwise direction until it is secure (Figure 5.8).
9. Attach pull chain extensions to the appropriate pull chains. Note: When facing the reverse switch, the light pull chain is on
the left and the fan pull chain is on the right (Figure 5.9).
Turn on power to fan at breaker box and the wall switch. Assembly is complete.
Blade Washer
Blade Screw
Figure 5.4
Light Pan Screw Key Hole Slot
Figure 5.7
Blade Arm
Light Pan
Blade
Slot
Figure 5.5
Light Kit
Figure 5.8
Fitter Plate Screw
Light Kit
Figure 5.6
Glass Bowl
Figure 5.9
8
Light Pan Screw
9-pin Connector
Light Pull Chain
Fan Pull Chain