Kenwood eXcelon KDC-X915 Instruction Manual page 10

General features
Function of the KDC-X915/KDC-X815
"Tre Frq" : Adjust the center frequency of the treble.
Setting values: 10.0 / 12.5 / 15.0 / 17.5 kHz
NOTE
This mode is available only when the Sound coordinate system is
on. (page 38).
"Tre" : Adjust the treble level.
Setting values: - 8 – + 8
"Balance" : Adjust the balance level.
Setting values: Left 15 – Right 15
"Fader" : Adjust the fader level.
Setting values: Front 15 – Rear 15
Function of the KDC-X915/KDC-X815
"NFpre Level" : Adjust the Non-fading output level.
Setting values: - 15 – + 15
NOTE
Not available during the Dual zone system is on.
"HPF Front" : Adjust the frequency of the High-pass filter for
front output.
Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
NOTE
You can separately set the high-pass filter for front and rear
output,including preouts. The high-pass filter does not affect the
non-fading preout. The factory default settings for front output
and rear output are "Throu" .
"HPF Rear" : Adjust the frequency of the High-pass filter for rear
output.
Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
NOTE
You can separately set the high-pass filter for front and rear
output,including preouts. The high-pass filter does not affect the
non-fading preout. The factory default settings for front output
and rear output are "Throu" .
"LPF NFpre" : Adjust the frequency of the Low-pass filter for
Non-Fading output.
Setting values: 50 Hz / 80 Hz / 120 Hz / Through
NOTE
Not available during the Dual zone system is on.
— 10 —
Function of the KDC-X915/KDC-X815
Function of the KDC-X915/KDC-X815
Function of the KDC-X915/KDC-X815