Storage - Kubota GR1600-ID-2 Operator's Manual

68

STORAGE

STORAGE
To avoid serious injury:
A To reduce fire hazards, allow the engine and
exhaust system to cool before storing the
machine in an enclosed space or near
combustible materials.
A To avoid the danger
poisoning, do not operate the engine in a
closed building without proper ventilation.
A Do not clean the machine with engine running.
A To avoid fire hazards, Do not leave grass and
leaves in the mower.
A When storing, remove the key from the key
switch to avoid operation by unauthorized
persons.
When the machine will not be operated for over 2 months,
clean the machine and perform the following operations
before storage.
1. Repair parts as necessary.
2. Check bolts and nuts and tighten as necessary.
3. Apply grease or engine oil to parts most likely to rust.
4. Inflate the tires to a little above the standard pressure
levels. (Approximately 110%)
5. Lower the mower to the ground.
6. Remove the battery from the machine. Store the
battery following the battery storage procedures.
(See "Battery Condition" in "EVERY 50 HOURS" in
"PERIODIC SERVICE" section.)
7. Drain fuel tank, fuel lines.
8. Store the machine where it is dry and sheltered from
rain. Cover the machine with a tarpaulin.
9. Moisture content in most grasses can damage the
mower if these components are not properly cleaned
after use.
Make sure the mower is clean before storage.
10. Jack the machine up and place blocks under the front
and rear axles so that all 4 tires are off the ground.
Keep the tires out of direct sunlight and extreme heat.
A When washing the machine, be sure to stop the
engine. Allow sufficient time for the engine to cool
before washing.
A Cover the machine after the muffler and the engine
have cooled down.
1. Check the tire inflation pressure and adjust as
2. Install the battery. Before installing the battery, be sure
3. Do daily checking. (See "DAILY CHECK" in
of exhaust fume
4. Check all fluid levels. (engine oil, hydrostatic oil)
5. Start the engine. Shut the engine off and walk around
6. Run engine a couple of minutes before you put engine
7. With the engine fully warmed up, release the parking
REMOVING THE MOWER FROM STORAGE
required.
it is fully charged.
"PERIODIC SERVICE" section.)
the machine and make a visual inspection looking for
evidence of oil or other fluids.
under load.
brake and test the brakes for proper adjustment as you
move forward. Adjust the brakes as necessary.