NEC WT600 Setup Manual page 15

• Press the SELECT
sor with [Top], then press the SELECT
to allow adjustment of the protrusions and inden-
tations of the upper edge of the projected image.
• Press the SELECT
sor with [Bottom], then press the SELECT
ton to allow adjustment of the protrusions and in-
dentations of the lower edge of the projected im-
age.
2. Press the ENTER button when [Pincushion] is completed.
Return to the menu.
3. Press the CANCEL button a few times to make the menu disappear.
NOTE:
• In the [Pincushion] screen, when the [Top] adjustment value is "0", adjustment of [Bottom] will
not be possible*.
Also note that when the adjustment value of the [Top] is a small value (on the order of +5), there
will be almost no change of the image even when the [Bottom] is adjusted.
• In the [Pincushion] screen, when the [Bottom] adjustment value is less than "0", a small portion
can be lost at the bottom area of the image. To display the lost portion, use the [Digital Zoom]
function to reduce the size of the projected image*.
• When [Cornerstone] or [Keystone] has already been adjusted, selection of [Pincushion] will not
be possible. To display [Pincushion], return the adjustment values of [Cornerstone] or [Key-
stone] to the factory shipping conditions.
* Each note for [Top] and [Bottom] is reversed when the [Ceiling Rear] or [Ceiling Front] is se-
lected in [Orientation] .
Reference
The [Pincushion] screen can also be displayed from the advanced menu by going to [Projector
Options] → [3D Reform].
E-12
button and align the cur-
button
button and align the cur-
but-
Screen (solid line)
Projected area (dotted line)
Screen (solid line)
Projected area (dotted line)