Antenna; Cable Tv Connection - Philips 42PF100062 Quick Start Manual

A combination antenna receives normal broadcast channels (VHF 2–13 and UHF 14–69).Your connection is easy
because there is only one 75 (ohm) antenna jack on the side of your TV, and that's where the antenna goes.
1 1
If your antenna has a round cable (75 ohm) on the end, then you're
ready to connect it to the PLASMA TV. If your antenna has fl at,
twin-lead wire (300 ohm), you first need to attach the antenna
wires to the screws on a 300- to 75-ohm adapter(not supplied).
2 2
Connect the antenna (or adapter) to one end of the supplied L-
Adapter as shown, and connect the other end of the L-Adapter to
the TV jack on the side of the PLASMA TV.
3 3
Plug the power cable into AC inlet on PLASMA TV set. Plug the
power cable into an outlet and switch TV set on.
4 4
Run the AUTO PROGRAM function to set up the TV for the
broadcast or cable channels available in your area. If you do not run
the auto program function to set up the channels , your television
may not operate properly
H H E E L L P P F F U U L L H H I I N N T T
• Remember, an antenna or cable TV signal must first be
connected to your PLASMA TV
• Please make sure that you have selected the TV mode with
AV key on your remote control, before installing TV channels.
Your Cable TV input into your home may be a single (75 ohm) cable or use a cable box decoder. In either case the
connection is very simple. Follow the steps below to connect your cable signal to your new television
D D i i r r e e c c t t c c a a b b l l e e c c o o n n n n e e c c t t i i o o n n s s : :
1 1
Connect the Cable TV signal to one end of the supplied L-
Adapter as shown, and connect the other end of the adapter to
the TV jack on the PLASMA TV
2 2
Plug the power cable into an outlet and switch TV set on
3 3
Run the AUTO PROGRAM function to set up the TV for the
broadcast or cable channels available in your area. If you do not
run the auto program function to set up the channels, your
television may not operate properly
H H E E L L P P F F U U L L H H I I N N T T
• Remember, an antenna or cable TV signal must first be
connected to your PLASMA TV.
• Please make sure that you have selected the TV mode with
AV key on your remote control, before installing TV
channels.
All manuals and user guides at all-guides.com

ANTENNA

CABLE TV CONNECTION

14
CVBS L R
SCART 1 SCART 2
ANT.IN
S-Video
AV
KABLOLU
YAYIN
C C A A B B L L E E
B B R R O O A A D D C C A A S S T T I I N N G G
CVBS L R
SCART 1 SCART 2
ANT.IN
S-Video
AV
ON
POWER
OFF
AUDIO
L
R
ON
POWER
OFF
AUDIO
L
R