2.2
Installing the Module/Removing the Module
EN655 is one slot type module. It is fixed to the base with both upper/lower lock levers and
mounting screws. Turn power OFF before installing and removing modules.
Procedure for installing
(1) Turn off the power of EN655 module and external power supplied to I/O modules.
(2) Check the mounting position of EN655.
Base-Unit
BU648E
BU643D
BU668
BU666
BU664
NOTE
1.
Total
the maximum output power rating.
For the electricity consumption of each module, refer
Controller Unit Instruction Manual (6F8C1220). Chapter 2.6 Power Supply Calculation"
2.
Install the module as close as possible to the CPU module (S0).
Table 2-1 Locations where EN655 can be installed
S0
S1
S2
×
○
○
×
○
○
×
○
○
○
○
○
○
○
○
electricity consumption
of modules installed in the same base
Unified Controller nv series Ethernet Module (EN655) Instruction Manual
2.2 Installing the Module/Removing the Module
(○ : Install OK, x: Install NG, - : NO SLOT)
SLOT No.
S3
S4
S5
S6
S7
○
○
○
○
○
○
―
―
―
―
○
○
○
○
○
○
○
○
―
―
○
―
―
―
―
to" Unified Controller nv series
S8
○
―
○
―
―
must not exceed
11